Pro Key Box Guide: Simplifying Key Programming Steps
- lnsert the programmer into the onboard diagnostic (OBD) port. It is located on the driver's side under the lower dash panel. Then follow the screen instructions.
- Next, insert the original key into the ignition and turn it to the start position to start the vehicle. Then press enter.
- Then turn off the ignition and remove the original key from the ignition. Press enter on the Pro Key Box screen to continue and now insert the NEW KEY without turning the car on. Then press enter to continue.
- Wait up to 20 Seconds and listen to hear the beeping noise. Once you hear this noise, the key has been successfully paired. Remove the key from the ignition.
-
Finally, Test the key and make sure it can start the vehicle.
Cart
Close
Back
Account
Close
